Schwinn MPower Echelon2 Console Installation Manual page 33

Pairing and Calibrating the 4iiii Powermeter:
1. Press and hold STAGE
2. Use AVG/MAX to scroll until SENSOR TYPE is displayed then push the back-light button
sor menu. Ensure that "4iiii" is displayed as the sensor type.
3. If the sensor type is set to "Echelon 2" press the back-light button
MAX button to select "4iiii" then press the back-light button
4. Once "4iiii" is selected the console will enter the pairing process, check the side of the power sensor for a 4 OR
5-digit ANT+ ID code. Enter this code on the "ENTER ANT ID" screen using AVG/MAX to scroll and the back-light
button to enter the ANT+ ID.
5. Once the ANT+ ID has been entered, pedal the bike, then select "PAIRING SPIN CRANK" but pushing the back-
light button . If pairing does not pass, check to ensure the ANT+ ID is correct and try the pairing process
again. It may take 2-3 attempts to pair successfully.
6. After successfully pairing the 4iiii crank, the power sensor must be calibrated BEFORE riding the bike. Press and
hold STAGE and AVG/MAX for 3-5 seconds to access the service menu then use AVG/MAX to scroll until
"CALIBRATE" is displayed and push the back-light button
light button once more and ensure that the left crank arm is in the 6 o'clock position, follow the on-screen
directions to calibrate the sensor.
and "AVG/MAX" for 3-5 seconds to access the service menu.
to select the sensor type, use the AVG/
again.
. "ZERO RESET" will be displayed, press the back-
to access the sen-
3
Page 33