Schwinn MPower Echelon2 Console Installation Manual page 12

19. Remove the top and bottom screw from the front of the
chain guard
20. Position the RPM sensor as shown and reinstall the two
chain guard screws. The RPM sensor should be appx.
2-3mm away from the fl ywheel, or about the width of a
credit card.
If the RPM sensor is too close, it will rub against the sensor
magnet that is embedded in the fl ywheel. If the RPM sensor
is too far away, the sensor will intermittently pick up a sig-
nal from the magnet or will not pick up any signal at all; this
will cause an erratic RPM display, or no RPM display
21. Prior to applying the lower conduit, clean the surface of the
inner right fork with isopropyl alcohol and allow to air dry.
22. Peel the non-stick strip off the plastic conduit base (yellow).
23. Attach the base (blue) fi rmly on the inside of the right hand
fork. There should be about one inch gap between chain
guard/rpm sensor bracket and the wire conduit.
The top of the conduit should be as high as the beginning
bend in the fork
Page 12
2.63 mm 2.63 mm