SubSurface Instruments AML PRO Operator's Manual page 24

Marking the Exact Location of an
Object with the AML Pro
Remember that the 10º forward projection
of the blade will make the object appear
closer than it actually is (see figure 24-1).
Once the object is found, pivot the handle
of the AML Pro upward until the blade (or
bottom of the AML Pro) is perpendicular to
the ground and directly above the area of
the signal (see figure 24-2). You can now
scan the ground in parallel for the entire
length of the object, identifying its diameter
or width, location and run direction as you
track the object.
Note: Read the Safety Notes section
(pages 3-4) before operating your AML
Pro.
To prevent most irrelevant positives from
being identified, decrease the sensitivity
level to the lowest setting that will still
identify the object.
Searching Position:
Objects are further than they appear
when in the searching position.
Blade Face
Figure 24-1
Note: Read the Safety Notes before operating your AML Pro.
24
10°
Locating Position:
Tilt the handle 10º when locating the
exact edge of an object.
Blade Face
Figure 24-2
10°