Table of Contents
Advertisement
ASSEMBLING HEAD TO MACHINE FRAME
The following steps should be done with the help of a second person.
1) Position the head (A) Fig.7 up against the frame (B) and secure head to frame
using 5 large cap screws and washers (C) Fig.7 and (A) Fig.8.
2) Secure the head to the frame by tightening the 5 cap screws using the supplied
8 mm hex. key (D) Fig.7, which can be found in the hex. key storage.
INSTALLING SLIDING TABLE ONTO FRAME RAILS
1) Before attempting to install the sliding table on the frame rails, the table stop
(C) Fig.9 must be positioned in the "unlocked' position as shown in the
illustration below.
2) Slide the sliding table (A) Fig.9 onto the frame rails (B) by setting table rollers
under the table onto the rails. Once engaged slide table towards the back of
the Tile Saw.
3) To prevent the table from sliding off the rails, turn table stop (C) Fig.9 in the
"locked' position as shown in the illustration above.
4) To secure the table and prevent it from sliding, push in the table lock (D) Fig.9
into one of the holes in the front rail.
INSTALLING EXTENSION TABLE TO SLIDING TABLE
1) Loosely install extension table lock knob (A) Fig.10 into the front side of the
sliding table (B).
2) Slide extension table (C) Fig.10 between the extension table lock knob (A) and
the sliding table (B) as shown. Tighten extension table lock knob to secure
extension table.
ASSEMBLY
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
Advertisement
Table of Contents
