JVC FS-SD5 Schematic Diagrams page 8

Removing the CD mechanism base
assembly (See Fig.6 to 13)
Prior to performing the following procedure, remove
the rear cover, the side covers and the front panel
assembly.
1. Remove the four screws E attaching the CD door on
the upper side of the body.
2. Disconnect the card wire from connector CN104 and
CN105 of the main board in the front part of the
body. Disconnect the card wire from CN101 of the
main board on the right side, and the harness from
CN705 and CN708 of the CD mechanism base
assembly respectively.
3. Remove the four screws F
mechanism base assembly on the upper side of the
body. Remove the screw I
terminal on the right side.
4. Remove the screw G attaching the heat sink board
on the back of the body. Disconnect the harness
from connector CN301 and pull the heat sink board
fully outward.
F
CN804
attaching the CD
attaching the earth
CD mechanism base assembly
Fig.9
E
CD door
CD mechanism base assembly
CN104
CD mechanism base assembly
Main bard
CN101
CD mechanism base assembly
Heat sink board
G
FS-SD5/FS-SD7/FS-SD9
Fig.6
Main bard
CN105
Fig.7
F
CN705
CN708
Fig.8
CN301
Fig.10
E
I
1-7