JVC FS-SD5 Schematic Diagrams page 14

Removing the jack board (See Fig.33)
Prior to performing following procedure, remove the
CD mechanism board.
1. Disconnect the harness from connector CN502 on
the jack board.
2. Remove the four screws V attaching the jack board.
Removing the switch board (See Fig.33)
Prior to performing following procedure, remove the
CD mechanism board.
1. Disconnect the harness from connector CN502 on
the jack board.
2. Remove the six screws W
board.
Removing the LED board
1. Disconnect the harness from connector CN706 on
the CD mechanism board on the underside of the
CD mechanism base assembly.
2. Push inward the two tabs d attaching the LED board
case and release them.
3. Pull out the LED board from the LED board case.
attaching the switch
(See Fig.34 and 35)
V
Jack board
V
V
W
CN502
Fig.33
Tabs d
CD mechanism board
Fig.34
LED board
Fig.35
FS-SD5/FS-SD7/FS-SD9
Switch board
W
LED board case
1-13