Transmitting Barcode Data To A Host - Feig Electronic PAN MOBILE ID ECCO Lite User Manual

IDENTIFICATION ID ECCO:Lite 8 Transmitting Data to a Host

8 Transmitting Barcode Data to a Host

Transmitting Data to a Host
Batch mode
All barcodes scanned in batch mode are saved in the file "Output.txt" on the removable drive "SCANNDY".
Connect the device to the host computer via USB and use the Windows-Explorer to navigate to the device
"SCANNDY". Copy the file "Output.txt" to the host.
To delete the data from the device just delete the file "Output.txt".
Transmitting data from a Bluetooth device
When the scanner is paired to a host via Bluetooth, the data transmits to the host after each scanning
procedure and is not stored on the scanner unless the scanner moves out of the range of the host. For out of
range usage you can configure the device to either store the data in a cache memory or do not allow
scanning.
If the device was configured to store the out of range captured data, it stores the data in the file "Output.txt".
After reconnection press key 3 + key 4 for 2 seconds to transmit all cached data to the host.
Page 18 of 23