Elite Screens Kestrel Series Instructions
Version 2 rf remote synchronization
Hide thumbs
Also See for Kestrel Series:
- White paper (10 pages) ,
- User manual (8 pages) ,
- How to replace (7 pages)
Advertisement
Quick Links
¡ ¢ £ ¤ ¥ ¦ ¡ ¢ £ ¤ ¥ § ¨ © ¦ ¡ ¢ £ ¤ ¥ ¢ ¨ ¤ ¢ ¤ ¢ ¨
RF Remote Synchronization Instructions
(For Electric Floor Rising /Floor Rising Tensioned Projection Screens only)
1. Connect the power cord and supply power to the screen
2. Switch the red power button to the ON position.
Manual Operation Switch: The left side of the screen's housing includes a UP/STOP/DOWN toggle switch
to raise, stop, and lower the screen.
3. Switch the button to the "UP" position and allow the screen to raise some distance until the control
box behind the screen is visible.
12/9/2016-DR
www.elitescreens.com
1
Advertisement
Related Manuals for Elite Screens Kestrel Series
Summary of Contents for Elite Screens Kestrel Series
- Page 1 ¡ ¢ £ ¤ ¥ ¦ ¡ ¢ £ ¤ ¥ § ¨ © ¦ ¡ ¢ £ ¤ ¥ ¢ ¨ ¤ ¢ ¤ ¢ ¨ RF Remote Synchronization Instructions (For Electric Floor Rising /Floor Rising Tensioned Projection Screens only) 1.
- Page 2 4. Open the control box, located behind the screen, by pressing where the two arrows are shown in the picture below. This will allow the cover to pop off. Note: If the cover is difficult to remove, try firmly pressing and carefully lifting one side at a time. 5.
- Page 3 10. Assemble the Control box. Please align the edge of the Control box cover with left bottom groove, and then press the cover slightly. You will hear two "clicks" as it clasps on. For Technical Support or a local Elite Screens Contact, please visit www.elitescreens.com 12/9/2016-DR www.elitescreens.com...