Fireco Dorgard Pro Handbook page 18

Red radio LED
and red alert
on device
State
This is indicating that the device has lost
communication with its parent Transmitter/
Repeater. The device will be in a fail safe condition.
If the lost device is a Repeater, any connected
devices will also fail to safe.
Check
Check the state of the parent Transmitter/Repeater of
the lost device for power and/or faults. If the system has
multiple Repeaters, it may be necessary to check all parents
to identify the primary source of the fault.
Fix
The fault should be resolved at the primary device where the fault was detected. If no fault with the
parent and the fault is isolated to the device, it may be caused by loss of signal due to range.
!
Page 16
Fix
!
Carry out a site survey to ensure sufficient range
! Dorgard Pro
where the device is located, it may be necessary to:
Re-site Transmitter or Repeater;
OR bind the device to different Repeater;
OR add another Repeater to the system to
increase range.
Troubleshooting