Fireco Dorgard Pro Handbook page 10

Dorgard Pro Place the Survey Dorgard Pro at the position
a Dorgard Pro is to be fitted. Hold it at the bottom of the
fire door.
Depress the plunger to get a radio reading. If the Dorgard
Pro is in range of the Survey Transmitter, the top LED of
the Dorgard Pro will show solid green for 4 seconds. If the
Survey Dorgard Pro is not in range, the top LED will show
red for 4 seconds.
Freedor Pro Place the Survey Freedor Pro at the position
a Freedor Pro is to be fitted. Fit to the correct side of the
door, using the adjustable bracket provided.
Press the button on the front of the Freedor Pro to get a radio reading.
If the Freedor Pro is in range of the Survey Transmitter the right LED of
the Freedor Pro will show solid green for 4 seconds. If the Survey
Freedor Pro is not in range the right LED will show red for 4 seconds.
Repeat this process for all of the doors you wish to survey.
!
4. Repeater Location
To identify a suitable location for the new Repeater bring the
Survey Pro device closer to the Survey Transmitter until you are
again in range (confirmed by a green LED).
Dorgard Pro
!
Dorgard Pro
!
Dorgard Pro
!
Page 8
Dorgard Pro
!
Dorgard Pro
!
Dorgard Pro
!
Dorgard Pro
!
Dorgard Pro
!
To connect out of range devices, you will need to
install a repeater to extend the range.
Repeat steps 3-4 from this position.
When survey is complete, switch transmitter to
the off position to conserve battery power.
Survey and
demo
Do
!
Dorgard Pro
!
!