Section 4: Troubleshooting - Fireco Dorgard Pro Handbook

Failing
to bind
Pro devices
State
The Pro devices will indicate failure to bind by
showing the radio LED and alert LED as red.
It will then take itself out of bind mode.
4
Fix
If problem persists it is likely the Pro device is out of range. We recommend you carry out a site
survey - see section 2.
It may be necessary to re-site the Transmitter or Repeater closer to the Pro device;
OR
bind the Pro device to a different Repeater;
OR
add another Repeater to your system to increase the coverage.
Page 14
Check
1. Check that the Transmitter or Repeater to which
you want the Pro devices to bind is in bind mode.
The Transmitter or Repeater will be flashing its radio
LED green.
2. While the Transmitter or Repeater is in bind
mode, push the bind button on the Pro device.
The Pro device will flash its radio LED green and retry
binding to the Transmitter or Repeater.
Troubleshooting
Dorgard Pro
!
Dorgard Pro
!