Advertisement
Binding
Information is communicated from the transmitter
to the Pro devices via radio. All devices need to be
bound together as a system.
This can be thought of as a family tree. The
transmitter is a parent device sending information.
Pro devices are children receiving information.
A repeater is both a parent and a child as it both
receives and sends information.
4
2. When the bind is successful, the radio LED will go
solid green on both parent and child for 4 seconds.
The child will no longer be in bind mode but the parent
remains in bind mode for an hour or until the bind
button is pressed again.
3. Should a repeater be required, it needs to be bound
to the parent in the same way as a pro device. When
successfully bound, it will carry out a radio channel
scan to select the strongest available channel.
The power LED will flash amber during scanning.
The repeater is now in parent mode and pro devices
and further repeaters can be bound to it.
NOTE
If during installation and set up the system identifies different versions of software in the devices, it will
trigger an over the air update, indicated by the parent displaying an amber alert LED. If successful, the
LED will turn green, if unsuccessful, it will turn red. To retry, press the bind button twice, repeat process
until successful.
!
Dorgard Pro
!
1. To start the bind process, press the blue bind button
on the base of the Transmitter/Repeater (parent). The
radio LED will flash green, indicating in bind mode.
The pro device you wish to connect now needs to be
put into bind mode. This can be done by pressing the
bind button.
Dorgard Pro The bind button can be accessed through
the front casing using a 3mm screwdriver. The radio
LED will flash green to indicate in bind mode.
Freedor Pro The bind button is located on on the PCB,
accessed by removing the cover.
Dorgard Pro
!
Installation
!
Dorgard Pro
!
Page 11
Hide quick links:
Advertisement
