Scanning Computers (F4); Tuning (F5); Moving The Label (F6) - Tripp Lite NetCommander B072-008-1 Owner's Manual

Operation

Scanning Computers (F4)

You can adjust the scan time in the Time Settings window (see Figure 13).
To activate scanning:
1. Press the [Shift] key twice to activate the OSD.
2. Press the [F4] key.
Each active computer will be displayed in sequence. A Scan label appears in the top left corner.
To deactivate scanning:
Press [F4].

Tuning (F5)

You can tune the image of any remote computer screen.
To adjust the screen image:
1. Move to the remote computer you want to adjust.
2. Press the [F5] key. The screen image of the selected computer is displayed, along with
the Image Tuning label.
3. Adjust the image by using the Right and Left Arrow keys.
4. When the image is satisfactory, press [Esc].
Note! Distance affects picture quality. The further away a remote computer is from the
KVM, the lower the image quality and the more tuning needed. Therefore put any
higher resolution computers closer to the KVM.

Moving the Label (F6)

You can position the OSD label anywhere on the screen.
To position the label from the Main window:
1. Move to the desired computer using the Up and Down Arrow keys.
2. Press the [F6] key. The selected screen image and Identification label are displayed.
3. Use the arrow keys to move the label to the desired position.
4. Press [Esc] to save and exit.
(continued)
15