Setting Connection Network; Connection Network Using Wps Mode (Method 1) - Panasonic CS-XE9WKUAW Service Manual

17.4.2.3

Setting Connection Network

ConnectionGuide
Step1 Step1 Step2 Step2 Step3 Step3
Make sure smartphone is connected to same
wireless network.
When Wireless LAN LED is ON, tap "Next".
Point the remote control to air -
condi oner
and press the "Wireless LAN" bu on once.
When Wireless LAN LED is blinking, tap "Next".
S E T Wir eless LA N
CANCEL
LED
Wir eless LA N Wir eless
LAN bu on bu on
Next
Cancel
1. Ensure Wireless LAN LED is ON.
point the remote control to air conditioner
and press Wireless LAN
Wireless LAN LED changed to blinking.
17.4.2.4

Connection Network Using WPS Mode (Method 1)

ConnectionGuide
Step1 Step3
Step2
The router supports WPS.
Connect with WPS mode
The router does not supports WPS.
Connect with AP mode
Cancel
1. Select 'Connect with WPS mode'.
ConnectionGuide
Step 1
Wireless LAN LED.
LED is OFF
LED is ON
LED is Blinking
2. When Wireless LAN LED is blinking,
select preferred connection setup mode.
button until the
Connection Guide
Step1
2. Press the "WPS" button from the
router that will be connected to an air
conditioner.
Check the status of Wireless LAN LED
●
on the remote control. If the Wireless
LAN LED is OFF, press the Wireless
LAN
LAN connection.
Step 3
Step 2
Cancel
Step2 Step3
Next
Cancel
button to enable the Wireless
139
ConnectionGuide
Step1 Step2 Step3
The router supports WPS.
Connect with WPS mode
The router does not supports WPS.
Connect with AP mode
Cancel
3. Select the preferred router support
connectivity mode.
Connection Gu ide
Step1 Step2 Step3
If Wireless LAN LED is OFF during the connec on
setup, please press "Wireless LAN" bu on once
to enable the Wireless LAN before proceeding to
step .
Press and hold "Wireless LAN"bu on for 5
secs un l easy se ng " 1" is shown.
Point remote control to air-condi oner and
press "SET" bu on once.
A er step & have been done, tap "Next".
SET
CANCEL
Next
Cancel
3. Ensure Wireless LAN LED is ON. Press
and hold the Wireless LAN
for 5 seconds until "1" is shown on the
remote control and press
to the air conditioner.
button
pointing
SET