Verify Color Mode - Siemens ACUSON S2000 Installation Instructions Manual

28
4. Select the name of the connected transducer from the transducer list located in the
upper-left corner of the monitor.
a) Roll the trackball to position the pointer over the name of the connected transducer.
b) Press the Select key.
Fig. 29:
5. Rotate the 2D knob clockwise
the screen becomes brighter.
CAUTION
6. Press the Freeze button and disconnect the transducer from the left port.
Fig. 30:
Place the transducer in a safe place.
7. Press the Freeze button again to exit the Freeze mode and return to imaging.

Verify Color Mode

1. Press the C knob
2. Rotate the C knob
The region of interest (ROI) (green) and the color tools are active.
3. Adjust the ROI position.
ACUSON S2000
NOTE
When the system displays the transducer name, the system
has recognized the connected transducer.
Connecting or disconnecting the transducers while in imag-
ing mode may affect the image.
(7/Fig. 11 / p.
(7/Fig. 11 / p. 19)
US15-101.812.01.02.02
05.10
System Delivery Procedure
(3/Fig. 11 / p. 19) to verify that the main display area of
Put the system in Freeze mode prior to connecting or
disconnecting transducers.
19).
to enable color imaging.
Page 28 of 40
Ultrasound
0
Siemens