6.4
Installing a server node
6.4.1
Removing the server node dummy module
I
The CX400 M4 system must always run with closed node bays. It is only
allowed to leave a bay open for a limited time in case of repairing a server
node (for example). In the meantime all remaining server nodes run in
throttling mode (with reduced performance).
V
CAUTION!
Follow the safety instructions in the chapter
●
on page
Figure 30: Removing the server node dummy module
Ê Undo the locking mechanism (1) of the release lever and pull the server
node dummy module out of the bay (2).
6.4.2
Installing the CX2550 M4/M5 or CX2560 M4/M5
server node
V
CAUTION!
Follow the safety instructions in the chapter
●
on page
CX400 M4
29.
29.
Operating Manual
Operation
"Important information"
"Important information"
69