Fujitsu PRIMERGY CX400 M4 Operating Manual page 70

Operation
Ê Push the server node at the handle into the server enclosure until the locking
mechanism snaps into place.
Ê If applicable, connect all external cables to the server node.
V
CAUTION!
When connecting and removing the tubes from the node, check that the
LC flexible tubes riser is not off as shown.
70
I
Ê Remove the gasket of the
Ê Push the server node at the
I
Ê Install the gasket of the
Operating Manual
Only necessary for
CX2550 M4 and CX2560
M4 server nodes!
lower server node and keep
it for later use.
handle into the server
enclosure until the locking
mechanism snaps into
place.
Only necessary for
CX2550 M4 and CX2560
M4 server nodes!
lower server node again.
CX400 M4