Back Panel Model Gss108Epp; Switch Hardware Interfaces; Rj-45 Ports For 10/100/1000M Base-T Ethernet Connectivity - NETGEAR GSS108E Hardware Installation Manual

8-Port and 16-Port Gigabit Ethernet (PoE+) Smart Managed Plus Click Switch
Table 3. Front panel status LEDs model GSS108EPP (Continued)
LED
RJ-45 left port LEDs for
ports 1–8
These LEDs indicate the link
status, speed, and activity of
the port.
RJ-45 right port LEDs for
ports 1–4 only
These LEDs indicate the PoE
status the port.

Back panel model GSS108EPP

The back panel does not contain any components other than a recessed Factory Default
button (see Factory Defaults button on page 18).
The following figure shows the back panel.
Figure 6. Back panel model GSS108EPP

Switch hardware interfaces

The following sections describe the hardware interfaces on the switch.

RJ-45 ports for 10/100/1000M BASE-T Ethernet connectivity

All RJ-45 copper ports support autosensing. When you insert a cable into an RJ-45 port,
the switch automatically ascertains the maximum speed (10 Mbps, 100 Mbps, or 1 Gbps)
and duplex mode (half-duplex or full-duplex) of the attached device. All ports support
a Cat 5e cable (or higher-rated Ethernet cable) terminated with an 8-pin RJ-45 connector.
Hardware Overview
Description
Solid green. A valid 1000 Mbps Ethernet port link is established.
Blinking green. The port is transmitting or receiving packets at 1000 Mbps.
Solid yellow. A valid 10 Mbps or 100 Mbps Ethernet port link is established.
Blinking yellow. The port is transmitting or receiving packets at 10 Mbps or 100
Mbps.
Off. No Ethernet port link is established.
Off. The port is not delivering PoE.
Solid green. The port is delivering PoE.
Solid yellow. A PoE fault occurred. For more information, see PoE troubleshooting
suggestions (model GSS108EPP) on page 39.
17 Hardware Installation Guide