Toro E-Z Vac 78570 Operator's Manual page 13

7
Installing the Bagger Tube
Parts needed for this procedure:
1 Tube
1 Hose clamp
2 Blower clamp
Procedure
1. Thread 1 end of the tube into the hood until it
forms approximately a 90-degree bend from the
blower and is secure
Figure 19
1. Tube
2. Secure the other end of the tube to the blower
assembly using the hose clamp and 2 blower
clamps (Figure 20).
Note:
Loosen the knobs, slide the blower
clamps onto the knobs so that the rear knobs
are in the rearmost slot, and tighten the knobs.
Ensure that the hose is between the blower
clamps and the blower assembly.
(Figure 19).
1. Tube
2. Blower clamp (2)
g037657
13
Figure 20
3. Hose clamp
g185954