Inspecting The Bagger; Inspecting The Mower Blades; Installing The Mower Blades - Toro E-Z Vac 78570 Operator's Manual

Figure 27
1. Blower assembly
2. Pulley
8. Remove the existing bagger belt from the deck
and blower assembly.
9. Install the belt around the blower and idler
pulleys as shown in
10. Install the pulley that you removed so that the
belt is routed around it.
11. Close the blower assembly so that the handle
latches.

Inspecting the Bagger

Service Interval: Every 100 hours
After the first 8 hours
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check the upper tube, lower tube, bagger hood,
and the blower assembly. Replace these parts if
they are cracked or broken.
4. Check the bags, bagger frame, and screen.
Replace any parts that are cracked or broken.
5. Tighten all nuts, bolts, and screws.
3. Hex nut
Figure 26.
- position, and
LOCK
Inspecting the Mower
Blades
1. Inspect the mower blades regularly and
whenever a blade strikes a foreign object.
2. If blades are badly worn or damaged, install new
blades. Refer to the Operator's Manual for the
machine for complete blade maintenance.

Installing the Mower Blades

g038469
In most mowing conditions, the standard high-lift
blades provide the best bagging performance.
Use a Toro Atomic blade for bagging leaves in dry
conditions. In dry dusty conditions, the medium lift
or low lift blades reduce dust and dirt blowout while
providing effective bagging air flow.
Contact an Authorized Service Dealer for the proper
blades for different mowing conditions.
Refer to the machine Operator's Manual for more
information on installing blades.
20