enphase IQ 7 Series Installation And Operation Manual page 33

Topic
High AC voltage trip limit accuracy
Low AC voltage trip limit accuracy
Frequency trip limit accuracy
Trip time accuracy
Overvoltage class AC port
AC port backfeed under single fault
Power factor setting
Maximum microinverters per 20A (max) AC branch circuit
3
240 VAC (single phase)
208 VAC (single phase)
CEC weighted efficiency
240 VAC (single phase)
208 VAC (single phase)
Static MPPT efficiency (weighted, ref EN 50530)
Total harmonic distortion
Ambient temperature range
Night tare loss
Storage temperature range
Compatibility
Dimensions not including mounting bracket
Connector type
Weight
Environmental category / UV exposure rating
Torque specifications for fasteners
(Do not over torque)
Cooling
Relative humidity range
Approved for wet locations
Pollution degree
Limits may vary. Refer to local requirements to define the number of microinverters per branch in your area.
3
.
33
IQ 7 / IQ 7+ / IQ 7X / IQ 7A with EN4 Bulkhead Installation and Operation
Enphase IQ7-60-E-US Microinverter Parameters
Miscellaneous Parameters
Features and Specifications
Pairs with most 60-cell PV modules (the PV module DC
conductors must be labeled "PV Wire" or "PV Cable" to be
compliant with NEC for Ungrounded PV Power Systems)
212 mm x 175 mm x 30.2 mm (approximate)
Enphase EN4 bulkhead
1.08 kg (2.38 lbs.)
NEMA type 6 / outdoor
•
•
•
Natural convection - no fans
4% to 100% condensing
Yes
PD3
© 2020 Enphase Energy Inc. All rights reserved.
Unit Min
mVrms
mVrms 179
% ±0.1
milliseconds
A
%
%
%
C
-40
mW
C
-40
6 mm (1/4") mounting hardware: 5 N m (45 to 50 in-lbs.)
8 mm (5/16") mounting hardware: 9 N m (80 to 85 in-
lbs.)
When using UL 2703 mounting hardware, use the
manufacturer's recommended torque value
Typical Max
280
±0.1% or 2 cycles
III
0
1.0
16
13
97.0
96.5
99.0
5
+65
50
+85
141-00047-01