Advertisement
7. Booster Test
EnergyLab XM includes a 2 Amp
Booster that can be used for DC and
impedance measurements. Click on
the (+) next to
Additional Tests
to
open the folder, and select the
Booster Module Test. The actual test
setup can be examined and changed
if needed by expanding and clicking
that part of the project tree.
Click on
Booster Module Test
to display the Experiment / Run Menu
for the default test. This shows the booster connected to the 0.1 ohm
test cell that is more suited to higher current tests. Connect as shown.
To run the test, make sure that
EnergyLab XM is selected in the
Experiment / Run Menu, then click
on the
Run
key. Measurements
should start and the following
display should appear (graphs
can be configured as before):
Advertisement
