Philips AVENT SCF315 User Manual page 23

Problem
Cracking/
Discoloring
Components are
broken or lost.
Pump does not
response.
Pump motor
display flashes
3 seconds, then
shuts down
automatically.
The silicone tube
is too loose when
it is plugged into
machine or cap.
Solution
Avoid contact antibacterial or abrasive
•
detergents/ cleaners. Combinations of
detergents, cleaning products, sterilisation
solution, softened water, and temperature
fluctuations may cause the plastic to
crack. If any crack is found, stop using
the pump immediately. Contact Philips
Avent Consumer Care center for spare
components.
Food coloring can discolor components,
•
but this will not affect your usage.
Keep all the components away from the
•
source of heat or direct sunlight as it can
discolor components.
Contact Philips Consumer Care center
•
0800 231 099 for spare components.
Make sure the pump is correctly assembled
•
and press the power button to switch on.
Make sure the cables between the pump
•
and the power socket are correctly
connected.
When using the power adapter to supply
•
power, make sure you are using the one
Philips provided. Then make sure it is
connected properly, then switch the pump
on again.
If you use batteries to supply power, press
•
the power button to switch off. Replace
with new batteries and switch the pump on
again.
After checking the 2 scenarios above, if the
•
problem persists, contact the Consumer
Care center for help.
Contact Philips Consumer Care center
•
0800 231 099 to buy and change a new
silicone tube.
EN 23