Cleaning And Maintenance - PHILIPS Respironics InnoSpire Elegance Manual

Instructions for use
Remove the compressor from carrying case if supplied before use.
After unpacking the device, check the compressor and accessories for visible damage or
1
defects such as cracks in the plastic housing which could expose electrical components.
Contact Philips Respironics customer service or your product distributor to report any
damaged product.
When taking a treatment, sit upright and relaxed.
2
Plug the compressor into the electrical outlet.
3
Refer to the nebulizer and accessory instructions for use before treatment.
4
To start the treatment, switch the device ON by pressing the ON / OFF switch onto the "I"
5
position.
When the treatment has been completed, switch the unit OFF by setting the switch position
6
to "O" and disconnect the plug from the electrical outlet.

Cleaning and maintenance

During cleaning, make sure the power cord is not plugged in the electrical
outlet.
Cleaning of the compressor, nebulizer and accessories
Wash the nebulizer and accessories according to its instructions.
Use a clean damp cloth to clean the outside of the unit.
Replacement of the nebulizer
The nebulizer and other accessories should be replaced according to its instructions.
Replacement of the filter
The filter is to be replaced when it appears discolored or wet.
Ambient conditions
Storage conditions
Temperature MIN -25 °C – MAX 70 °C (-13 °F – 158 °F)
Humidity MIN 10% RH – MAX 95% RH
Operating conditions
Temperature MIN 5 °C – MAX 40 °C (45 °F –104 °F)
Humidity MIN 10% RH – MAX 95% RH
Altitude From 0 – 2000 m above sea level
Operating atmospheric pressure Performance may vary depending on altitude above sea level,
barometric pressure and temperature
Troubleshooting The device
does not turn on
• Make sure the plug is firmly fitted to the electrical outlet.
In the event of malfunction (insufficient pressure and flow) turn the unit off for 10 seconds and
turn back on.
After each cleaning, check that the unit is working properly by verifying that air still comes
out of the nozzle when the unit is turned to the "ON" position. Unauthorized repair voids
warranty.
If the device does not work properly after attempting these troubleshooting steps, contact your
authorized product distributor or Philips Respironics Customer Service at (inside the US) 1-800-962-
1266, (outside the US) +33 1 47 52 30 00.
Maintenance and repairs
Never open the device. There are no serviceable parts within the unit. The compressor requires no
lubrication or maintenance.
Technical specifications
Electricity supply 120V/60Hz 1.7 Amp
Thermal overload protector Thermal fuse; functioning temperature 150 C°
Compressor max. pressure 303 kPa (44 psi)
ENGLISH