Remove The Solid-State Drive (Ssd) And The Ssd Screw Rubber; Remove The Wi-Fi Card - Lenovo ThinkBook Plus Hardware Maintenance Manual

Remove the solid-state drive (SSD) and the SSD screw rubber

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and then remove the SSD by pulling it away from the slot.
Figure 6. Remove the SSD
Screw specifications
M2 x L5
Step 3. Remove the SSD screw rubber.
Figure 7. Remove the SSD screw rubber
Go to
https://support.lenovo.com/partslookup
replacement part:
SSD
SSD screw rubber

Remove the Wi-Fi card

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
32
Hardware Maintenance Manual
Number of screws
1
to look up the Lenovo part numbers of the following