Connecting To A Wi-Fi Network - Hunter Hydrawise PRO-HC Quick Start Manual

CONNECTING TO A WI-FI NETWORK

When your controller is first powered on, it will run a short wizard to connect it to your
wireless router.
If you're not using the initial startup wizard, then go to the Wireless Settings section to
make changes. For support, please contact hunter.direct/prohchelp.
Using the wizard
1. Select your wireless network from the list shown on the controller display
and press the Confirm button on screen.
Note: If your network is not listed, check if the unit is
within wireless range.
2. Enter your wireless password and press the OK button on keyboard.
Note: Make sure you press the OK button after you've
entered your password. Pressing the Home
buttons will not save your changes.
When connecting to your wireless network, the Wi-Fi icon
controller screen will flash. Connecting takes about 30 seconds and when successfully
connected the Wi-Fi icon will stop flashing and stay on.
or Back
at the bottom right of the
8