Advertisement
4.
Insert the M10 x 40 mm bolts from the inside so that
the threaded ends of the bolts face outwards. Fit a
M10 lock nut to the bolt on the left hand side of the
motorcycle and tighten to 45 Nm.
2
cdjv
1. Bolts
2. Centre stand
5.
Recover the shim from the kit and attempt to insert it
(without using force) between the mounting bracket
on the frame and the centre stand on the right hand
side of the motorcycle.
2
cdjv
1. Shim
2. Centre stand
3. Frame mounting bracket
1
3
1
3 of 5
Installing the shim by force will prevent the centre stand
from retracting fully, or may result in damage to the
frame or centre stand. Riding the motorcycle with a
centre stand which does not retract fully, or with a
damaged frame or centre stand, may interfere with the
rider and could affect the stability or other aspects of the
motorcycle's operation which may result in loss of
motorcycle control and an accident.
6.
If the shim does not slide freely between the stand
and the frame, discard the shim and continue from
step 7. If the shim slides freely between the stand
and the frame, install it as described below:
• Remove the bolt on the right hand side of the
motorcycle, withdraw the flanged sleeve and fit
the shim between the frame mounting bracket
and the centre stand. Refit the flanged sleeve.
• Refit the bolt as described in step 4, fit the lock
nut and tighten to 45 Nm.
• Check the operation of the centre stand, ensuring
the stand operates freely and properly. If the stand
does not operate freely, remove the shim, fit a
new lock nut (supplied) and tighten to 45 Nm.
Continue from step 8.
7.
If the shim is not required, fit the lock nut to the bolt
on the right hand side of the motorcycle and tighten
to 45 Nm.
8.
Fit the rubber stop to the rear hole on the left hand
silencer bracket then insert the stop extension
through the hole in the rubber stop.
2
1. Silencer bracket
2. Rubber stop
3. Stop extension
Warning
1
3
Advertisement
