Triumph A9758013 Fitting Instructions

Scrambler centre stand kit

Download this manual

English

Fitting Instructions:

Scrambler

Centre Stand Kit - A9758013

Thank you for choosing this Triumph genuine accessory kit. This accessory kit is the product of Triumph's use of proven

engineering, exhaustive testing, and continuous striving for superior reliability, safety and performance.

Completely read all of these instructions before commencing the installation of the accessory kit in order to become

thoroughly familiar with the kit's features and the installation process.

These instructions should be considered a permanent part of your accessory kit, and should remain with it even if your

accessory equipped motorcycle is subsequently sold.

Parts Supplied:

Centre stand

Lock nut, M10

Spring

C-bracket

Flanged sleeve

Publication part number A9900226 issue 5, ADC 12919

T908.00.00

1 off

Bolt, M10 x 40 mm

3 off

Spring retainer

1 off

Lock nut, M8

1 off

Shim, 2.5 mm

2 off

10. Sachet, grease (not shown)

1 of 4

2 off

1 off

Need help?

Do you have a question about the A9758013 and is the answer not in the manual?

Page 1 Scrambler Centre Stand Kit - A9758013 Thank you for choosing this Triumph genuine accessory kit. This accessory kit is the product of Triumph's use of proven engineering, exhaustive testing, and continuous striving for superior reliability, safety and performance. Completely read all of these instructions before commencing the installation of the accessory kit in order to become thoroughly familiar with the kit’s features and the installation process.
Page 2 Note: Triumph model or to any other manufacturer’s motorcycle. Fitting this accessory kit to any other Triumph model or to • On California models, release and reposition the any other manufacturer’s motorcycle, may interfere with the evaporative canister to improve access.
Page 3 Insert the M10 x 40 mm bolts from the outside so that Warning the threaded ends of the bolts face inwards. Fit a M10 lock nut to the bolt on the left hand side of the Installing the shim by force will prevent the centre stand motorcycle and tighten to 45 Nm.
Page 4 • On California models, refit the evaporative contact an authorised Triumph dealer and do not ride the canister. Tighten the fixings to 12 Nm. motorcycle until the authorised dealer has declared it fit for Operate the centre stand a few times then re-torque use.