Philips blender hr2066/55 600 w 2 litre (120 pages)
Summary of Contents for Philips HL 7600
Page 1
Wet Grinding Jar / Multipurpose Jar Your Mixer Grinder comes with different jars for different applications. The wet jar (HL 7620 and HL 7610) / multipurpose jar (HL 7600) with the black gasket and can be used to prepare shakes, purees, batters and for liquidizing.
Page 2
Dry Grinding Jar The dry jar (HL 7620, HL 7610) with the dry grinding blade can be used for dry grinding like making masalas.
Page 3
Chutney Jar The chutney jar can be used to prepare chutneys, masalas or nuts in smaller quantities.
Page 4
Maximum recommended quantity for each jar Type
o f
J ar
Rated
C apacity
Wet
C apacity
( Rated)
Dry
C apacity
( Rated)
Wet
G rinding
J ar
1.3L
...
Page 5
Attaching and Removing Wet and Dry Jar Your Mixer Grinder is equipped with a safety lock mechanism. This will prevent the appliance from starting if the jar is not properly mounted on the base unit. Place the jar at the ‘unlock’ position and twist clockwise...
Page 6
Attaching and Removing Chutney Jar To lock the chutney jar, place it on the base unit with the locking arm to the right side of the knob. To lock the jar into place, twist it clockwise to align the locking bar with the ‘locked ’...
Page 7
DO NOT: There is only one locking position for the chutney jar. The appliance will not operate till the jar is locked in the correct position.
Page 8
Attaching Chutney Jar Lid 2. Twist the lid in the clockwise direction till it locks into the groove... 1. To make the appliance further safe to use, the chutney jar is equipped with a lid lock. To lock, place the lid on the jar at an angle as shown...
Page 9
Removing the Chutney Jar Lid To open the chutney jar lid, twist it in the anti- clockwise direction.
Page 10
DO NOT: Do not pull or push the lid Ensure that the lid is to open or lock. Always completely locked twist to open and close the lip on the lid is the lid. aligned with the jar. If not aligned, the appliance may still run but this will increase the chances of breakage.
Page 11
Changing the Blade An extra wet blade, that can be used to make lassi and batters, has been given with your appliance. To change the blade: 1. Hold the coupler on 2. Use the spanner the underside of the jar supplied with the mixer with one hand to remove the blade by...
Page 12
Overload Protection Switch To protect the appliance from damage, it is equipped with an ‘Overload Protector’ (OLP) switch which will cut off the power supply if the jars are overloaded or run for a long time. To reset the appliance: 1.