Table Of Contents - Mennekes AMTRON Xtra Installation Manual

Wechs el ein- auf z weis paltig
About this Document
© Copyright MENNEKES Elektrotechnik GmbH & Co. KG
Content subject to changes without notice.
This document is protected by copyright. It helps to ensure
the device is used safely and efficiently by the user. The
contents may not be duplicated or reproduced, in whole or
in part, without the prior consent of the copyright holder.
Document symbols
 Listing
 Check / Result
Tip
 Reference to another page in this document
 Reference to another document

Table of Contents

1 General .................................................................. 2
1.1 Structure of the installation instructions .................. 3
2 Safety .................................................................... 3
2.1 General Safety Information ..................................... 3
2.2 Safety Information .................................................. 4
2.3 Intended Use ........................................................... 4
2.4 Qualification of Personnel ....................................... 4
2.5 Warranty ................................................................. 4
2.6 Returning Devices ................................................... 4
3 Product Description .............................................. 5
3.1 General information ................................................ 5
3.2 Optional equipment ................................................ 5
3.3 Identification Plate .................................................. 6
3.4 Delivery Contents .................................................... 7
3.5 Assembly................................................................. 7
3.5.1 Exterior view ............................................... 7
3.5.2 Interior view................................................ 8
3.6 Components ........................................................... 9
3.6.1 Front panel ................................................. 9
3.6.2 HC controller ............................................ 10
4 Technical Data .................................................... 11
4.1 General data ......................................................... 11
4.1.1 Maximum cable cross-sections at terminals11
4.2 Ambient conditions ............................................... 11
5 Installation .......................................................... 12
5.1 Choice of location ................................................. 12
5.2 Unpacking ............................................................ 12
5.3 Opening the charging station ................................ 13
1
5.4 Assembly .............................................................. 13
5.4.1 Minimum distances .................................. 13
5.4.2 Installing the supply cable ......................... 13
5.4.3 Installing the charger station on the wall .. 14
5.5 Electrical connection ............................................. 15
5.5.1 Voltage supply / supply network connection
................................................................ 15
5.5.2 Safeguarding and personal protection ...... 15
5.5.3 Terminals .................................................. 16
5.5.4 LAN connection ........................................ 17
5.5.5 Tariff-switching signal ............................... 17
5.5.6 RS485 bus ................................................ 18
6 Commissioning ................................................... 19
6.1 Turning on the charging station ............................ 19
6.2 Setting up the network connection ....................... 19
6.2.1 LAN connection (Ethernet) ........................ 19
6.2.2 WLAN connection .................................... 19
6.3 Configuration of the charging station ................... 19
6.3.2 Access over LAN ....................................... 19
6.3.3 Calling up the service interface ................. 20
6.3.4 Setting up a direct connection (access point
mode) ....................................................... 20
6.3.5 Setting up the connection to the wireless
home network .......................................... 21
6.3.6 Time synchronisation ................................ 21
6.3.7 Menu description ..................................... 22
6.4 MENNEKES Charge APP ........................................ 26
6.4.1 Requirements ........................................... 26
6.4.2 Automatic connection of the Charge APP . 26
6.4.3 Manual connection of the Charge APP ..... 27
6.5 Checking the charging station .............................. 28
6.6 Closing the charging station ................................. 29
7 Operation............................................................ 29
7.1 General information on operation ......................... 29
7.2 LED Info bar .......................................................... 30
7.3 Multi-function button ........................................... 31
7.3.1 Terminating an on-going charging process 31
7.3.2 Re-activating the residual current circuit
breaker and circuit breaker ....................... 31
7.3.3 Testing the integrated residual current circuit
breaker (RCCB) ......................................... 31
7.4 Description of operating modes ............................ 32
7.4.1 Settings in operating mode "Energy
Manager" ................................................. 37
7.5 Charging the vehicle ............................................. 38
7.5.1 Charging without authorisation ................ 38
7.5.2 Authorisation with RFID ............................ 38
7.5.3 Authorisation with Charge APP ................ 38
7.5.4 Mode 3 charging ...................................... 39
7.5.5 Terminating the charging process ............. 39
7.5.6 Power failure during charging process ...... 39