Manual Warnings; Safety Information - Dimplex Edel EDL200UK-630 Installation And User Instructions Manual

1 Manual Warnings

Electrical Warnings
Indicates any hazard of an
electrical nature
Information
Indicates tips and advice for the
smooth operation of the system.
General Warnings
Indicates a general warning against
actions which could result in
!
damage to the system or personal
injury to the installer and/or user.

2 Safety Information

This appliance can be used by
children aged 8 years and above
and persons with
!
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given
supervision or instruction
concerning use of appliance in
a safe way and understanding
the hazards involved - some
parts of this product can be-
come hot and cause burns.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made
by children without supervi-
sion.
No isolating device may be
fitted between the inlet group
!
and the cold water inlet on the
cylinder, as by doing so
important safety devices could
be isolated!
The maintenance of this
appliance must be carried out
by suitable
only. It is recommended to
maintain the unit on an annual
basis. Isolate all electrical
supplies from the unit before
commencing work.
Danger of electrical shock!
It is important that the tundish
is positioned away from any
electrical components.
Means for electrical
disconnection must be
incorporated in the fixed wiring
in accordance with the wiring
rules.
.
qualified person
Safety Information
Before removing the cover from
the immersion heater isolate the
appliance using isolating switch!
Danger of electrical shock! Only
use suitable electrically
insulated equipment when work-
ing inside immersion housing.
The cylinder must be filled with
water before switching on the
immersion heater. Failure to do
so will damage the element and
void the warranty.
The appliance should be
installed in a place where it is
not exposed to damp and is not
at risk of being splashed with
water.
It is important to check the
pre-charge pressure of the
expansion vessel membrane
before filling the cylinder. This
has been factory set to 3 bar.
The pre-charge should be
greater than or equal to 3 bar.
A high level cut-out is fitted to
the product for each heat source.
This should never
activate under normal
operation.
Please retain manual for future reference.
If an electronic copy of this manual should be
required, please contact the
manufacturer at the address at the back of this
manual.
4