Warnings - Dimplex DHW 301P Installation And Operating Instructions Manual

English

1. Warnings

1.1. Intended use
This device is only intended for use as specified by the
manufacturer. Any other use beyond that intended by
the manufacturer is prohibited. This requires the user
to abide by the relevant project planning documents.
Please refrain from tampering with or altering the de-
vice.
1.2. Important notes
ATTENTION!
Read these installation and operating in-
structions before commissioning!
ATTENTION!
Work on the domestic hot water heat pump is
only to be performed by qualified personnel.
Observe accident prevention regulations!
ATTENTION!
The device cover cannot be used for carrying
(the cover cannot withstand significant
forces).
ATTENTION!
Once the heat pump has been set up, the
chock must be removed from the air intake.
ATTENTION!
The heat pump may only be transported in
an upright position (see "Transport" chapter).
ATTENTION!
When installing the on-site pipework, ensure
that the pipes are not contaminated (flush
pipes before connecting the domestic hot
water heat pump if necessary).
ATTENTION!
The domestic hot water heat pump must
only be operated when filled with water.
ATTENTION!
Disconnect the power supply before open-
ing the domestic hot water heat pump; pos-
sible fan coasting must be considered.
ATTENTION!
Risk of injury caused by sharp-edged fins.
Fins must not be deformed or damaged.
EN-4
ATTENTION!
Disconnect the power supply before open-
ing the device.
1.3. Regulations / safety notes
ATTENTION!
Read these installation and operating in-
structions before commissioning.
The domestic hot water heat pump is used exclusively
to heat water for domestic use and drinking water
within the specified operating temperature limits.
Heating of fluids other than domestic water is not per-
mitted. Technical regulations for domestic water in-
stallation are to be observed. The nominal pipe widths
for the on-site sanitary installation must be determined
taking into account the building-specific requirements
and the valid directives and regulations. Any necessary
safety devices, such as pressure reducing valves,
must be installed according to the specific require-
ments.
The following are not permitted:
Operating the pump with solvent-based or

explosive exhaust air
Use of exhaust air containing grease, dust or

aerosols
Connecting extractor hoods to the ventilation

system
It is not permissible to install the device:
Outdoors

In rooms which are exposed to frost

In rooms subject to high humidity (e.g. bath-

rooms)
In rooms with air which is potentially explosive

because of gases, vapours or dust
It is not permissible to operate the device
With an empty cylinder

During the construction phase of the building

The construction and design of the domestic hot water
heat pump complies with all relevant EU directives (see
also CE declaration of conformity).
FD 0303
Warnings
www.dimplex.de