Installing the Wall mount
h
Loosen the M6 bolt, and then adjust the vertical slide
i
Re-tighten the screws and bolts that you loosened in steps 3 to 8
Warning
Tighten all bolts and screws firmly. Otherwise, the product may fall and cause personal injury or
property damage.
j
Adjust the focus of position A in the following figure
k
When you have finished making adjustments, press the [Esc] button on the remote control
or the control panel to exit the guidance screen
Adjusting using the projector menus
c
You can save adjusted values in Memory from the Geometry Correction menu.
Before performing the adjustment, set the Screen Type setting first. If you change the Screen Type after
making corrections, the corrections will be reset.
64