Epson EB-1485Fi Installation Manual page 75

Installing the Control Pad
If any of the following problems occur, immediately turn off the power and unplug the AC
adapter and the power plug from the outlet. Next, contact your local dealer or the nearest
Epson service call center.

You notice smoke, strange odors, or strange sounds

Water or foreign material gets inside the control pad

The control pad was dropped or the case was damaged
Do not spill tea, coffee, juice or any other drinks on the AC adapter, or expose it to pesticides.
Failure to do so may cause a malfunction, a fire, or electric shock. If drinks or so on are spilled on
the AC adapter, turn off the power, unplug the AC adapter from the power outlet, and contact your
local dealer. Continuing to use it in this condition could cause a fire or an electric shock.
Do not install the AC adapter in a confined location or cover it with a cloth and so on except
for the AC adapter holder supplied.
Otherwise, the AC adapter may become hot and cause burns or unexpected accidents.
Do not wrap the power cable around the AC adapter.
Failure to do so may cause it to disconnect or overheat.
Do not disassemble or remodel the control pad.
Before cleaning, make sure you unplug the AC adapter and the power plug from the power
outlet and check that all of the wiring has been disconnected.
If it is not cleaned for a long time, dust may accumulate and cause a fire or electric shock.
Make sure you clean it regularly.
Do not disassemble the Control Pad when disposing of it.
Dispose according to your local or national laws and regulations.
In North America, interface cables that pass through walls require a flame resistant rating of CL2. Use interface
cables that comply with NFPA70 regulations. Use at least two screws to attach to wood.
This product is also designed for IT power distribution system with phase-to-phase voltage 230V.
Warning
Caution
74