Nibe S1155 Installer Manual page 46

MENU 4.2 - PLUS FUNCTIONS
Settings for any additional functions installed in S1155
can be made in the sub menus.
MENU 4.2.3 - SG READY
Here, you set which part of your climate system (e.g.
room temperature) will be affected on activation of "SG
Ready". The function can only be used in mains networks
that support the "SG Ready" standard.
Affect room temperature
With low price mode on "SG Ready" the parallel offset
for the indoor temperature is increased by "+1". If a room
sensor is installed and activated, the desired room
temperature is instead increased by 1 °C.
With over capacity mode on "SG Ready" the parallel
offset for the indoor temperature is increased by "+2".
If a room sensor is installed and activated, the desired
room temperature is instead increased by 2 °C.
Affect hot water
With low price mode on "SG Ready", the stop temperat-
ure for the hot water is set as high as possible with
compressor operation only (immersion heater not per-
mitted).
In the case of overcapacity mode on "SG Ready", the
hot water is set to large demand mode (immersion
heater permitted).
NOTE
The function must be connected to two AUX
inputs and be activated in menu 7.4 "Selectable
in/outputs".
MENU 4.2.5 - SMART PRICE ADAPTION™
Range
Here you select where (which zone) S1155 is in-
stalled.
Contact your electricity supplier to find out which
zone digit to enter.
Affect heating
Alternative: on/off
Degree of effect
Setting range: 1 - 10
Affect hot water
Alternative: on/off
Degree of effect
Setting range: 1 - 4
This function can only be used if your electricity supplier
supports Smart price adaption, if you have an hourly
tariff agreement and an active myUplink account.
46 Chapter 9 | Control - Menus
Smart price adaption™ moves the heat pump's consump-
tion over 24 hours to periods with the cheapest electri-
city tariff, which gives savings for hourly rate based
electricity contracts. The function is based on hourly
rates for the next 24 hours being retrieved via myUplink
and therefore an internet connection and an account for
myUplink are required.
You can choose which parts of the installation are to be
affected by the electricity price and to what extent; the
higher value you select, the greater the effect the elec-
tricity price has.
NOTE
A value that is set high may result in increased
savings, but may also affect the comfort.
MENU 4.4 - WEATHER CONTROL
Activate weath. contr.
Setting range: on/off
Factor
Setting range: 0 – 10
You can select whether you want S1155 to adjust the
indoor climate based on the weather forecast here.
You can set factor for outdoor temperature. The higher
the value, the greater the effect from the weather fore-
cast.
Caution
This menu is only visible if the installation is
connected to myUplink.
MENU 4.5 - AWAY MODE
When away mode is activated, the following functions
are affected:
• the setting for heating is lowered slightly
• the setting for cooling is raised slightly (accessory is
required)
• the hot water temperature is lowered if demand mode
"large" or "medium" is selected
• The AUX function "Away mode" is activated.
If you want, you can select for the following functions
to be affected:
• ventilation (accessory is required)
• hot water circulation (accessory is required)
NIBE S1155