Table Of Contents - Bubble Mk 2 PJ. CONVERSION Rayburn MF 19-12-05 Installation Information

1-8. See Separate Document. ____________________________________ 4
11. Fitting The Kit._____________________________________________ 4
1. Removing The Firebricks. ______________________________________ 4
1a. Remove The Thick Front Firebrick Beneath The Fuel-Loading Door. ______ 5
2. Remove The Oven Side Bricks. __________________________________ 5
3. Remove The Opposite Oven Firebricks. ____________________________ 5
4. Remove Fuel Loading Door Inner Cast Iron Protective Plate. ____________ 6
5. Remove The Ash pan. _________________________________________ 6
6. Remove the grate carrier. _____________________________________ 6
7 Remove The Riddling Grate Bars. _________________________________ 6
8. Remove The Riddling Grate Support Frame. _________________________ 7
9. Remove The Secondary Air Chamber Casting. _______________________ 7
10. Remove the secondary air chamber fasteners. ______________________ 7
11. Check The Hot Plate Seal. _____________________________________ 8
12.Remove The Flue Box Damper Plate. ______________________________ 8
13. Lock The Air Valve Open. _____________________________________ 8
12. Fitting The Boards And Burner Components. _______________________ 8
4. Start Fitting The First Boards. _________________________________ 9
5. Fit The Closure Plate._________________________________________ 9
6. Fit Opposite Oven Over Closure Plate Board. _______________________ 10
7. Fit Primary Closure Plate Board And Primary Front Board. _____________ 10
8. Fit Secondary Front Board. ___________________________________ 10
10. Fit The Fuel Loading Door Access Cover Plate. _____________________ 10
11. Fit Burner Base Plate. _______________________________________ 11
12. Fit Combustion Head. _______________________________________ 11
13. Fit The Air Hose To The Combustion Head. _______________________ 11
14. Fit The Fuel Pump. _________________________________________ 12
15. Tighten The Fuel Hose. ______________________________________ 12
16. Fit The Control Module. _____________________________________ 12
12b. Services Into The Burner. __________________________________ 13
1. Oil Feed. _________________________________________________ 13
2. Oil Isolation Valve.__________________________________________ 14
3. Oil Pipework To Pressure Jet Burners. ___________________________ 14
4. Power In. _________________________________________________ 14
5. Fit the baffle kit. __________________________________________ 14
6. Fit over oven baffle _________________________________________ 14
13. Commissioning._____________________________________________ 15
Contents
2