4-9. T .............. 6 HE COAL KIT cases, existing Bubble 1 users only have to run their 4- 10. D ..........6 ESCALING CONTROL stoves on the lowest setting, even through the very 4-11.
7. To ensure satisfactory performance from the provision made for guarding the exposed flue pipe BUBBLE stove chimneys must be capable of where a potential danger is presented. maintaining a constant steady vacuum of not less than .04"...
2-0-1. D 7. Outside the boat, the chimney should be twin wall OWNDRAUGHTING and insulated to keep the flue gasses as hot as 1. The contents of the chimney are equal to a possible. cylinder of hot air which depending upon its 8.
5. If the bubble stove is fitted up to the first bulkhead the isolation valve may well be fitted 3-0-4. O IL FEED SET UP outside the cabin or saloon of the boat and you 1.
The top frame x1 patented coal support system specially developed The stainless insert for the top frame x1 for use on BUBBLE STOVES. The small rear infill part of the stainless insert x1 2. The coals are located on the coal support bars,...
The front fender Replace the lower burning ring, the mesh catalyser and the coal kit and then leave the door slightly The top frame is secured to the top of the stove by open whilst the firelighter gets the oil going. one m6 fastener.
(STOVES WITH BOILERS) the oil to splash around and leak through the air holes in the side of the pot. 7. Has the oil trip lever tripped off? 7.0 ROUTINE MAINTENANCE 8. Has the boiler stat tripped off? 1. Every 4 weeks: 6-7.
Page 10
2. Where we do not hold returned warranty forms replacement parts would only be issued when we are sure that the appliance has not been damaged by improper use or incorrect installation. 3. The warranty covers PARTS ONLY for a period of ONE YEAR and is conditional upon all the requirements of our installation instructions being fully adhered to.
Need help?
Do you have a question about the CORNER OIL STOVE and is the answer not in the manual?
Questions and answers