Advertisement
10 millisecond automatic transfer between line and battery power supports UPS protection during blackouts and voltage fluctuations for
equipment compatible with a one half-cycle transfer time
750 watts continuous AC output in inverter mode
Double Boost inverter output supports momentary startup loads up to 200% of the continuous rating for up to 10 seconds (see specification
chart)
OverPower inverter output supports longer duration overloads to 150% for 1-60 minutes under ideal battery and temperature conditions.
(For best results, utilize OverPower usage for as short of a duration as possible, ensure battery bank and cabling is able to provide full
nominal DC voltage under load and allow inverter/charger to fully cool before and after OverPower usage.)
3-stage, selectable 5/20 amp battery charger with adjustable settings for wet/gel battery types offers fast, reliable battery recharging
Protected hardwire bolt-down input lugs safely accept heavy gauge input wiring from attached battery bank
Dual C13 output receptacles pass 120V line power or inverter output through to connected equipment
Reliability enhanced large-transformer design with secure mounting flanges and protected DC wiring terminals
Moisture-resistant construction enables vehicular or marine operation in high humidity environments
3 position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to
maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings
Set of six front panel LEDs display AC/DC operational modes, overload status, DC voltage level, shutdown status and system fault status
Set of 4 configuration dip switches support wet/gel battery charging profiles, charger enable/inhibit, and selectable 144/163/182/201V AC
low voltage auto transfer during brownouts
Set of 4 additional configuration dip switches support 4 levels of charger limiting relative to output load size, a battery equalization program
and battery charger low/high settings
Resettable 3A charger AC input breaker and resettable 4A AC output breaker and automatic 2-speed cooling fan protect the inverter from
load and temperature-related failures
Grounding lug properly connects the inverter/charger system to earth ground or vehicle grounding system
Automatic overload and thermal shutoff safely turns off inverter as excessive loads or overheating conditions develop
Front panel remote control connector enables remote off/on switching (requires APSRM4 switch accessory). Optional APSRM4 accessory
also includes user-configurable jacks to support inverter shutoff or startup as a vehicle ignition is engaged
Specifications
OVERVIEW
Intended
Emergency Home Power
Application
OUTPUT
Frequency
50 Hz
compatibility
Output watts
750
Continuous output
750
capacity (watts)
Peak output
1500
capacity (watts)
Output nominal
230V
voltage
Output voltage
LINE POWER (AC): Maintains 230V nominal sine wave output from line power source. INVERTER POWER (AC):
regulation
Maintains PWM sine wave output voltage of 230 VAC (+/-5%).
Output frequency
50 Hz (+/- 0.3 Hz)
regulation
Overload protection
Includes 3A input breaker dedicated to the charging system and 4A output breaker for AC output loads.
Outlet quantity /
2 AC outlets
type
INPUT
Advertisement
