Mounting - Tripp Lite RV Series Owner's Manual

Mounting

WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the Inverter/Charger and connected systems.
Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular
applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must
supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the
Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.
750 & 1250 Models Only
Whether mounted horizontally or vertically, the
Inverter must be located in an enclosed compartment,
shielded from outside weather conditions.
Using the measurements from the diagram, install two user-sup-
A
plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving
B
the heads slightly raised.
the fasteners to engage the mounting slots molded on the bottom of
the Inverter/Charger cabinet.
plied ¼" (6 mm) fasteners into the mounting feet molded on the
front of the Inverter/Charger cabinet.
The polycarbonate cabinet and mounting feet of your
Inverter/Charger are durable enough to allow for vertical mount-
ing as well, if your vehicle compartment requires this configura-
tion. For vertical mounting, the control panel of the
Inverter/Charger should face up.
C
6.75 in.
(17.1 cm)
7.87 in.
(20 cm)
Slide the Inverter/Charger back over
Install and tighten two user-sup-
C
Allow 2" minimum front and rear
clearance for adequate ventilation.
A
4.5 in.
(11.4 cm)
B
6.75 in.
(17.1 cm)
All Models Except 750 & 1250 Models
Note: When operating an RV2012UL marine model
in a marine application, refer to the accompanying
marine owners' manual addendum.
Whether mounted horizontally or vertically, the
Inverter must be located in an enclosed compartment,
shielded from outside weather conditions.
Using the measurements from the diagram, install two user-sup-
A
plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving
the heads slightly raised.
over the fasteners to engage the mounting feet molded on the
front of the Inverter/Charger cabinet. Install and tighten
additional user-supplied ¼" (6 mm) fasteners into the mounting
feet molded on the rear and sides of the Inverter/Charger
cabinet*. The rear feet extend beyond the unit's cabinet to
provide for adequate ventilation space behind the cooling fan(s);
they should not be removed.
The polycarbonate cabinet and mounting feet of your
Inverter/Charger are durable enough to allow for vertical mount-
ing as well, if your vehicle compartment requires this configura-
tion. For vertical mounting, the control panel of the
Inverter/Charger should face up.
Allow 2" minimum front and rear clearance for adequate ventilation.
5.57 in.
(14.16 cm.)
A
Note: RV model cabinets may have different front panel features, but all mount as per the figure above.
* All models include front and rear mounting feet. Select
models include side mounting feet.
10R
Slide the Inverter/Charger forward
B
5.57 in.
(14.16 cm.)
9.59 in.
(24.35 cm.)
B
5.87 in.
9.59 in.
(24.35 cm.) (14.91 cm.)
5.87 in.
(14.91 cm.)
1.64 in.
(4.15 cm.)