Mounting - Tripp Lite PINV300SW-120 Owner's Manual

Mounting

WARNING!
Mount your Inverter BEFORE DC battery connection. Failure
to follow these instructions may lead to personal injury and/
or damage to the Inverter and connected systems. Ensure the
inverter never is mounted in a vertical position (fan or outlet side
facing up or down). Mounting an inverter in a vertical position
allows debris to enter the unit and inhibit proper operation of its
cooling system, which can void the inverter's warranty.
Tripp Lite recommends permanently mounting the Inverter in the
configurations illustrated below. The Inverter features integral mounting
brackets on the unit. The user can use the included or user-supplied
mounting hardware and is responsible for determining whether
hardware and mounting surfaces adequately support the weight of the
unit.
Flat Surface
Mount
Use the measurements as shown in the following diagrams to install
two of the included or user-supplied fasteners at the DC side of the
unit, leaving the heads slightly raised. Slide the unit over the fasteners
to engage the mounting bracket slots. Tighten fasteners. Install two
additional fasteners over the remaining mounting brackets in the front
for proper securement.
Wall Mount
10