Tripp Lite RV Series Owner's Manual page 29

Specifications
(English)
Model Number:
Series Number:
AC Input Connection:
INVERTER
Common Specifications for All Models: • DC Input Volts (Nominal): 12 VDC • · DC Input Voltage Range: 10 - 15 VDC • Output Volts (Nominal): 120 VAC, ± 5% • Output Frequency (Nominal): 60 Hz, ± 0.5% • Efficiency: 88% to 94%,
depending on load and temperature
Tripp Lite Inverter/Chargers include a Battery Charge Conserver (Load Sense) Control which saves battery power by allowing users to set the minimum load level at which the unit's
inverter turns on. Users can significantly reduce the No Load DC Input Current (approximately 1 to 3 A for all models) to a very low amp level with the use of this control.
Continuous Power (@ 20 C ):
™
OverPower Peak Surge Power:*
™
DoubleBoost PeakSurgePower:*
Maximum Output AC Current
Continuous
UL-Recognized DC Fuse
Required
DC Input Current @
Nominal V DC Full Load:
BATTERY CHARGER
Common Specifications for All Models • Acceptance Volts VDC: (Wet** / Gel) 14.4 V** / 14.2 V • Float Volts DC (w/gel): 13.3 V (13.6 V) • · Input Volts (Nominal): 120 VAC
Charging Capacity DC:
Input Current AC:
LINE VAC OPERATION
Common Specifications for All Models • Input Frequency (Nominal): 60 Hz, ±10% • Maximum Input Volts (Transfer to Battery) 145 VAC Except OEM Models (Selectable 145V**/135V)
Minimum Input Volts: Selectable 75**, 85, 95 or 105 VAC
Transfer to Battery
Maximum Input AC Current
(Continuous, Charger at Maximum):
Maximum Bypass AC Current:
* OverPower duration (up to 1 hour). DoubleBoost duration (up to 10 seconds). Actual duration depends on battery age, battery charge level and ambient temperature. **Factory setting.
The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
Minimum Recommended DC Cable Sizing Chart
Use in conjunction with DC wiring connection instructions in the Battery Connection section.
Inverter/Charger DC Volt: 12
Wire Gauge vs. Maximum Distance from Unit to Battery
Watts 6 4 2 0 00 (2/0)
500 15 ft 25 ft 39 ft 62 ft 79 ft
700 11 ft 18 ft 28 ft 44 ft 56 ft
1000 N/R 12 ft 20 ft 31 ft 39 ft
2000 N/R N/R N/R 16 ft 20 ft
2400 N/R N/R N/R 13 ft 16 ft
3000 N/R N/R N/R 10 ft 13 ft
†
N/R = Not Recommended. NOTE: Acceptable power is directly related to cable length (i.e. - the shorter the cable, the better the performance)
RV750ULHW RV1250ULHW
AGAP5088 AGAP5094
Hardwire Hardwire
750
1125
1500
6.3 A 10.4 A
125 A 200 A
73 A 117 A
45 A** / 11 A 55 A** / 14 A
8.2 A
Selectable 75**, 85, 95 or 105 VAC
30 A
20 A
†
Twin 00 (2/0)
(RV2012OEM & RV3012OEM only)
158 ft.
112 ft.
78 ft.
40 ft.
32 ft.
26 ft.
RV2012UL
AP5626
Hardwire
1250 2000
1875 3000
2500 4000
16.7 A
two 175 A
190 A
100 A** / 25 A
11 A 20 A
Selectable 75**, 85, 95 or 105 VAC
33 A 38 A
20 A 30 A
RV2012OEM
AGAP200012MVP3
Hardwire
2000
3000
4000
16.7 A
two 175 A
185 A
100 A** / 25 A
21 A
Selectable 75**, 85, 95 or 105 VAC Selectable 75**, 85, 95 or 105 VAC
43 A
20/20 A
Note on Labeling
Two symbols are used on the RV labels.
V~ V
: AC Voltage : DC Voltage
1111 W. 35th Street, Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
RV3012OEM
AGAP4669
Hardwire
3000
4500
6000
25 A
two 275 A
282 A
140 A** / 35 A
25 A
30 A
20/20 A