Battery Removal And Installation; Removing A Psu From The Chassis - IBM Slicestor 2212 Appliance Manual

Figure 27. Removing a PSU from the chassis
2. Pull the PSU out using the provided handle. (The PSU wiring is designed to detach automatically
when the PSU is pulled from the chassis).
3. Replace the failed PSU with another PSU.
4. Push the new PSU into the power bay until you hear a click.
Install an SFP+ / QSFP optical module
1. Log in to the device as localadmin.
2. At the command prompt, type poweroff.
3. Remove the SFP+ / QSFP module from the packaging.
4. Remove the black plastic protective cap from the optical side of the module.
5. Insert the module into the network card until it clicks into place.
6. Insert the fiber optic cable into the SFP+ / QSFP module.
7. Restart system and configure the network interface. For more information, see the Appliance
Configuration Guide.

Battery removal and installation

Battery removal
To remove the Onboard battery, follow these steps:
1. Power off your system and unplug your power cable.
Chapter 6. Field replaceable or upgrade units
25