Installing The Inner Rails; Extending And Releasing The Outer Rails - IBM Slicestor 2212 Appliance Manual

Figure 11. Installing the inner rails
3. Slide the inner rail forward toward the front of the appliance until the rail clicks into the locked
position, which secures the inner rail to the appliance.
Important: Make sure all of the hooks are pushed through the holes in the rail and are not between
the rail and the appliance. Such a misalignment interferes with putting the appliance in the rack.
4. Secure the inner rail to the appliance with the screws provided.
5. Repeat these steps for the opposite inner rail.
6. The appliance is now ready to install into the rack, as shown in the following figure:
Figure 12. Inner rails installed on appliance
Install the outer rails on the rack
1. Press upward on the locking tab at the rear end of the middle rail, as shown in the following figure:
Figure 13. Extending and releasing the outer rails
2. Push the middle rail back into the outer rail.
Chapter 4. Install the appliance into a rack
11