Table of Contents
Advertisement
Administration
Customization
This configuration dialog allows the Administrator to set Timeout, Login failure, and Working
mode parameters.
An explanation of the Customization parameters is given in the table below:
Time Out Control
Login Failure
Working Mode
Reset on Exit
If the B014-000 is idle (doesn't receive any input from the computer that
currently has access to it) for this specified amount of time, it ends the
connection and becomes available for other users.
Login failures allowed, sets the number of consecutive failed login attempts
permitted from a remote computer. Login failure timeout, sets the amount of
time a remote computer must wait before attempting to login again after it
has exceeded the number of allowed failures.
If Stealth Mode is enabled, the B014-000 cannot be pinged.
If Echo Mode is enabled, the B014-000 will show up in the list of local
B014-000 units when the AP version of the Administrator Utility is run. The
B014-000 AP version is located on the CD that came with this package.
Placing a check here causes the B014-000 to reset itself and implement all
the administration changes that you have made when you log out. Wait
approximately 30 to 60 seconds before logging back in following the reset.
14
Advertisement
Table of Contents
