Programming Code Guide - ITS Telecom PanDoor Installation And Programming Manual

If an incoming call comes through the PSTN during the
programming process, a Call Waiting signal will sound.
If you switch to answer the call, the completed
programming settings are saved automatically.
To exit the programming mode:
•
Dial *900.
•
Hang up.
•
Timeout (default value: 45 seconds).
•
Switch to another panel or controller.
It is necessary to hang up between door panel
programming and entering a controller.
3.1

Programming Code Guide

The following programming guide provides a list of all possible
operations, commands and default values.
Operation
Access code
Unit:
Panel
PanDoor Installation and Programming Manual
Note
Note
Command
*110 + XX + YYY...+#
where:
XX = Access code number
(00-99)
YYY...= New Access code
(2-6 digits)
Note:
The capacity of access codes is 100
entries per panel.
Programming
Default
00=9876
15