Installing The Pandoor Panel - ITS Telecom PanDoor Installation And Programming Manual

Installation
2.2

Installing the PanDoor Panel

You can connect either one or two outdoor PanDoor units to a
single controller (indoor unit).
The PanDoor can be connected to an external bypass switch for
opening the door lock. This switch can be installed inside the
residence and should be connected to the SW and /SW
terminals on the PanDoor wire connector.
Figure 5 illustrates the terminal locations on the wire connector
of the outdoor panel. All wiring to the unit should be attached to
the wire connector. The wire connector is a screw connector
type. In order to attach a wire, you must insert the stripped end
of the wire into the appropriate terminal and tighten the terminal
screw. This will crimp the wire connection.
8 PanDoor Installation and Programming Manual