Yealink W52P Quick Installation Manual

You can configure the base station to obtain the network settings in one of the following
ways:
By default, the base station attempts to contact a DHCP server in your network to
obtain the valid network settings, e.g. IP address, subnet mask, gateway, DNS
server.
If the base station cannot contact a DHCP server for any reason, you need
to configure the IP address, subnet mask, gateway, primary DNS and secondary
DNS for the base station manually.
1. Press the key to enter the main menu, and select
.
2. Enter the system PIN (default: 0000), and press the
3. Select from the
4. Enter the valid values in the
fields.
5. Press the soft key to accept the change.
The wrong network settings may result in inaccessibility of your phone and may have an
impact on the network performance. For more information about these parameters, contact
your system administrator.
The handset in the W52P package is pre-registered to the base station. The internal
handset number and the handset name display on the idle screen after turning the
handset on.
If your handset is not pre-registered to the base station, you need to register it manually. For
more information, refer to Yealink W52P IP DECT Phone User Guide.
You can press the following predefined shortcut keys to access some frequently used
features of your handset when the handset is idle:
Press to access the call history.
Press to check the line status.
Press to place an internal call.
Press to access the directory.
Press to decrease the ringer volume.
Press to increase the ringer volume.
This helps you get quick access to features by pressing the shortcut keys directly without
having to scroll through the menu.
For more information, refer to the User Guide available online at:
c
Copyright 2013 YEALINK NETWORK TECHNOLOGY CO.,LTD.
->
soft key.
field.
, , ,
.
->
and
www.yealink.com
Applies to firmware version 10 or later.