Deleting Users; Changing The In-Home Bus Configuration; Changing The Call Button Assignment - SSS Siedle DoorCom Analog DCA 650-02 Programming Instructions Manual

Changing the user configuration

- Deleting users

Changing the In-Home bus configuration

- Changing the call button assignment

Deleting users
In order to ensure scope for later
expansion, only data of actually
assigned users should be stored in
the DCA 650-...
If more users have been registered
than actually exist, those which are
not required should be deleted.
Only the user which is currently
indicated in the display window
can be deleted.
In order to delete the user, press the
programming button.
Use the scroll buttons to change
between „no" and „yes".
Pressing the programming button
confirms the setting and returns you
automatically to main menu 3.
If required, the user configuration
must be performed for each user
in dividually as described under
point 3.
Changing the In-Home bus
configuration
On principle, a user must always be
already registered in the
DCA 650-... (main menu 2). The
configuration points are subdivided
into the following submenus:
Change call button assignment,
direct door selection and BSx actu-
ation.
With the scroll buttons, it is possible
to scroll through the submenus.
Changing the call button
assignment
Use the programming button to
move to menu point 4.1, Call button
assignment change. The system
always begins with user 1.
Use the programming button to
move to the user selection window.
3.5
Delete
change with
Delete
No
OK
3
User config
change with
4
In-home function
change with
OK
4.1
Call btn assignm
change with
OK
Display
USER 1
<OK>
Press the programming button
Display
USER 1
<OK>
Press the scroll button
Press the programming button
Display
<OK>
Display
<OK>
Press the scroll button
Press the programming button
Display
<OK>
Press the programming button