Instruction Sheet; Required Tools; Remove The Pump - Nordson ProBlue 1028303 Instruction Sheet

Instruction Sheet

Pump Service Kit - P/N 1028303
Use this service kit to replace the pump assembly in any ProBluet
adhesive melter. This kit contains two new O-rings that should be used to
replace the existing O-rings that are located between the pump and the
manifold.

Remove the Pump

1.
3.
Pump assembly
6-mm tube elbow
Parker lubricant
O-ring (top)
O-ring (bottom)
WARNING: Risk of personal injury or equipment damage! Refer to
the safety information provided in the melter manual before servicing
the melter. Failure to comply with the safety information provided
can result in personal injury, including death.
Switch the melter off.
Remove the pump as follows:
a. Rotate the isolation valve handle upward
until it is vertical.
d. Lift the pump clear of the melter.
2.
Relieve system hydraulic pressure. Refer to the
melter product manual for information on relieving
hydraulic pressure.
b. Remove the three pump-mounting bolts.
P/N 1029711A

Required Tools:

6-mm hex wrench
c. While pulling the pump away from the
manifold, tilt the top of the pump toward the
front of the melter and then disconnect the air
line from the back of the pump.
Note:
To gain leverage when removing the
pump, insert long M6 bolts into the two threaded
holes located on the front of the pump body.