1. Manuals
  2. Brands
  3. ETI Manuals
  4. Control Unit
  5. NETCOM ADH
  6. Replacement procedure

ETI NETCOM ADH Replacement Procedure

Automatic air dehydrator inlet solenoid module
Hide thumbs Also See for NETCOM ADH:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL ADH
NETCOM
®
AUTOMATIC AIR DEHYDRATOR WITH ETHERNET
®
ADH
NETCOM™ AUTOMATIC AIR
DEHYDRATOR INLET SOLENOID MODULE
REPLACEMENT PROCEDURE
Replacement Kit Part Number 24096
Document Part Number 24108
South Bend, Indiana USA
|
networketi.com
1
ADH INSTRUCTION MANUAL | PART NO.
24108
REV
B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NETCOM ADH and is the answer not in the manual?

Questions and answers

Related Manuals for ETI NETCOM ADH

Summary of Contents for ETI NETCOM ADH

  • Page 1 MODEL ADH NETCOM ® AUTOMATIC AIR DEHYDRATOR WITH ETHERNET ® NETCOM™ AUTOMATIC AIR DEHYDRATOR INLET SOLENOID MODULE REPLACEMENT PROCEDURE Replacement Kit Part Number 24096 Document Part Number 24108 South Bend, Indiana USA networketi.com ADH INSTRUCTION MANUAL | PART NO. 24108...

  • Page 2: Safety Information And Warnings

    SAFETY INFORMATION AND WARNINGS Abnormal Odor or Smoke Rack Mounting In the event of smoke or a burning or Before and after rack mounting the abnormal odor, immediately interrupt ADH NETCOM, ensure that the rack power to the ADH NETCOM with the is stable.

  • Page 3: Tools Required

    TOOLS REQUIRED ADH NETCOM INLET SOLENOID The following tools are needed to perform MODULE REPLACEMENT this procedure: PROCEDURE • 5/16” Nut driver • Phillips screwdriver This procedure addresses the removal and • Small flat blade screwdriver replacement of the Inlet Solenoid Module in •...
  • Page 4 INLET SOLENOID MODULE REMOVAL Shut off machine power by placing AND REPLACEMENT power switch in the OFF (O) position. With the power switch in the off position, unplug the power cord. If possible, move the dehydrator to a To replace the Inlet Solenoid Module work table.
  • Page 5 To Canister 1 To Canister 2 Position tubing wrench or hose pliers at these points. From the Compressor Figure 4. THE INLET SOLENOID MODULE AIR HOSE CONNECTIONS. Figure 3. DISCONNECTING THE AIR HOSES. Install the new mounting bracket with Connect the green power connector from the new inlet solenoid module the new inlet solenoid module over ®...
  • Page 6 To replace the Inlet Solenoid Module (23270) Remove and retain the four mounting in an ADH NETCOM AC NEMA, perform the screws from the four corners of the steps below. protective front cover, then slowly lift the front cover, carefully flip it over, Shut off machine power by unplugging then set it down, upside down, to rest the unit.
  • Page 7 Using a tubing wrench or vacuum tube Install the new mounting bracket with the pliers, grab hold of each of the three ® new inlet solenoid module over the Pem air hoses about 1 inch in from the end, studs from which the original module then pull gently to disconnect the mounting bracket was removed.

  • Page 8: Questions And Comments

    ETI, Inc. to notify any removed in step 3 of this section. person organization such Reconnect both ends of the orange revisions, changes or improvements.

This manual is also suitable for:

2409624108

Table of Contents